Login
Username:

Password:

Remember me



Lost Password?

Register now!
Main Menu
Who's Online
27 user(s) are online (8 user(s) are browsing Forum)

Members: 0
Guests: 27

more...
Top Posters
Report message:*
 

Re: Boolean operation (splitting primitive with another)

Subject: Re: Boolean operation (splitting primitive with another)
by rokkor3D on 2018/1/7 14:11:28

I made some learning and am getting desired shapes in objects using a primitive to cut another with Object > Slice command.

Here are three new objects that were made from over-lapping Plane and Tube primitives:

https://postimg.org/image/e9980fm3v/

I ungrouped the three objects with States > Ungroup command and proceeded with the disk made of plane. Using an over-lapping tube I pierced a hole and got four new objects.

The cut-in-half tube objects were not needed and were deleted leaving two desired objects:

https://postimg.org/image/vntg8coa3/

It appears that the Object > Slice command produces different results with different primitives even if the basic over-lapping shapes looked the same where the cut is made. For example, I could not get desired objects if I used Rod primitive instead of Tube primitive. Where the cut was supposed to happen the shapes looked the same but produced different results.

So it needs some experimenting to get the desired object slices.

To start slicing pick over-lapping primitives or objects by keeping shift pressed and drag a selection box around all objects selecting Mode > Drag Method > Drag Box.

That's it for now and getting busy slicing and joining suitable primitives and objects.
Search
Powered by XOOPS © 2001-2009 The XOOPS Project